Removal of trace Cr(VI) from aqueous solution by porous activated carbon balls supported by nanoscale zero-valent iron composites

Environmental Science and Pollution Research - In this study, porous activated carbon balls supported by nanoscale zero-valent iron composites (Fe@PACB-700) were used for the first time for the...     

石油化工企业含苯胺消防污水处理技术研究

针对石油化工企业含苯胺的消防污水,利用基于过氧化氢和氯化铁为氧化剂的深度氧化技术,通过氧化、絮凝、过滤和吸附对消防污水进行处理。实验确定氧化剂的投加量为理论投加量,氧化时间1.0h,消防污水pH值为6.86时,絮凝剂最佳使用浓度约为2%,消防污水中苯胺和COD去除率达到99.5%以上,达到了消防污水处理效果。     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

关于“十四五”土壤、地下水与农业农村生态环境保护的思考

净土保卫战和农业农村污染治理攻坚战是污染防治攻坚战的重要组成部分。本文对"十四五"及今后一个时期土壤、地下水和农业农村生态环境保护总体形势进行了分析,研究提出"十四五"目标指标、重点任务和政策措施的建议,提出坚持问题导向、目标导向,坚持分类施策、精准治污,以解决人民群众关心的突出环境问题为重点,实施一批源头预防、风险管控、治理修复重大工程,推进土壤、地下水和农业农村生态保护治理体系与治理能力现代化,为美丽中国建设提供坚实保障。     

利用卫星遥感评估广西壮族自治区SO_2减排成效

基于2005—2012年OMI卫星遥感PBL SO2柱浓度数据分析了广西壮族自治区SO2污染的时空格局和变化特征,并结合燃煤火电厂SO2排放模型估算与工业经济增长数据,在时间、空间尺度上分析了自治区内不同区域的SO2污染对火电厂烟气脱硫政策的响应以及所呈现出的减排成效。结果表明,广西因火电厂脱硫政策驱动的SO2污染改善具有显著的空间异质性,自治区内高污染区的SO2浓度在2011—2012年出现了显著下降,而低污染区的SO2浓度则在8年中持续增长;排放模型估算结果显示,烟气脱硫驱动的火电厂SO2减排贡献将在2008年后持续下降,而遥感观测结果显示,广西全区SO2半年浓度均值总体呈现波动上升趋势,2005—2012年浓度增加了8.6%、年均增长约0.9%;综合工业经济增长数据发现,近年来其他工业源的增量排放已给广西SO2减排带了新挑战,而这一变化仍未得到相关决策部门关注,存在明显缺陷的SO2统计排放量数据尚未得到修正。针对上述污染变化新特征,政府相关部门应引起足够重视,尽快更新完善污染源信息并启动针对其他污染源的限排措施,以确保环境持续改善。     

采用水解酸化-复合好氧处理制药工业废水的工艺评价

以制药工业综合废水处理为例对其采用的两级水解酸化复合好氧工艺的处理效果进行评估。按常规指标进行评估,该工艺对于制药综合废水的处理效果达到了设计目的,COD去除率可达到78.2%以上,NH+4-N的去除率达到99.3%,出水质量基本满足"污水综合排放标准(GB8978-1996)"二级标准和"辽宁省污水综合排放标准(DB21.1627-2008)";急性毒性的检测表明,经过该工艺处理后出水为低毒性;三维荧光谱分析(EEM)表明,制药综合废水经生物处理后的可溶性有机物中仍然存在难降解物质,建议增加物化处理以提高处理效果;并且制药废水经处理后的出水中的盐度对排入的生态系统存在风险,建议纳入排放标准以加强管理。     

电镀综合废水对DF膜的污染

江苏某电镀厂的电镀综合废水在采用DF膜进行预处理时,膜易受到污染。针对这一问题,采用DF膜生产厂家提供的小试装置,研究探索了膜污染的原因及其具体特征。实验结果表明,在处理电镀综合废水时,DF膜的污染速率较快,而酸洗对DF膜的恢复性较好,研究还证实电镀综合废水中的无氰沉锌水洗液是造成DF膜污染的主要原因。     

Sulfate-enhanced degradation of Rhodamine B in the hydrogen peroxide/hydroxylamine system

Environmental Chemistry Letters - Hydroxyl radicals are commonly produced either by metal activation or by using external energy. However, the application of these methods is limited by low working...     

The effect of moisture content within multilayer protective clothing on protection from radiation and steam

The moisture from skin sweat and atmospheric water affects the thermal protective performance provided by multilayer protective clothing. Four levels of moisture content were selected to evaluate the impact of moisture on thermal protection under dry (thermal radiation) and wet (thermal radiation and low-pressure steam) heat exposure. Also, the role of moisture and its relationship with exposure time were analyzed based on skin heat flux and Henriques integral value. The addition of moisture to a fabric system was found to result in differences in second-degree and third-degree skin burn times. When moisture is added to a fabric system, it both acts as a thermal conductor to present a negative effect and provides a positive effect owing to thermal storage of water and evaporative heat loss. The positive or negative effects of moisture are mainly dependent on the thermal exposure time, the moisture content and the presence of hot steam.     

Applying Statistical Causal Analyses to Agricultural Conservation: A Case Study Examining P Loss Impacts

Estimating the effect of agricultural conservation practices on reducing nutrient loss using observational data can be confounded by factors such as differing crop types and management practices. As we may not have the full knowledge of these confounding factors, conventional statistical meta‐analysis methods can be misleading. We discuss the use of two statistical causal analysis methods for quantifying the effects of water and soil conservation practices in reducing P loss from agricultural fields. With the propensity score method, a subset of data was used to form a treatment group and a control group with similar distributions of confounding factors. With the multilevel modeling method, data were stratified based on important confounding factors, and the conservation practice effect was evaluated for each stratum. Both methods resulted in similar estimates of the conservation practice effect (total P load reduction avg. ~70%). In addition, both methods show evidence of conservation practices reducing the incremental increase in total P export per unit increase in fertilizer application. These results are presented as examples of the types of outcomes provided by statistical causal analyses, not to provide definitive estimates of P loss reduction. The enhanced meta‐analysis methods presented within are applicable for improved assessment of agricultural practices and their effects and can be used for providing realistic parameter values for watershed‐scale modeling.